Roland R4000 Manual page 58

Communication with the PLC
5.2.4 Bus address
The bus address of the SND40 (Slave address) is assigned in the system configuration with the
parameters "field bus address" and "baud rate".
Depending on the type of fieldbus, the valid range of values is different.
Example with Fieldbus interface in the Profibus DP version:
Fieldbus address: 1
•
(here the address 1 is entered)
•
Addressing the ProfiNet module
The MAC-ID is hardware preset and cannot be set / changed. It will be displayed in the hardware
info of the SND40.
At the machine control the SND40 can be identified by this MAC-ID.
Settings of bus address and baud rate (depending on fieldbus type):
Fig. 33: SND40 Fieldbus address
58
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Weld Seam Detection System R4000 SND40
for Tubes, Cans and Drums
Note:
The range of values is not checked by the SND40 during the input.
Manual
B0059001 / Rev. 2.3