Legacy Alarms & Indicators; Common Alarm Indicator & Other Alarm Triggers; Alarm Led Summary Table; Viewing Alarms - HindlePower ATevo Series Operations

HindlePower Inc
9. 9. Alarms & Indicators Alarms & Indicators
9.1. 9.1. Legacy Alarms & Indicators Legacy Alarms & Indicators
ATevo alarms can be divided into two groups, Legacy ATevo Alarms and Advanced Alarms.
The Legacy Alarm group is a superset of the standard alarm group recommended by the
NEMA-PE5 and IEEE standards for stationary battery chargers. These alarms have dedicated
front panel LED indicators and are referred to as legacy alarms since they have the same
functionality as the standard alarms available on legacy ATevo Series battery chargers.
The green AC ON LED indicator, and the six (6) red Legacy Alarm LED indicators are
summarized in the table in
The table identifies:
• alarm active while LED is lit
• condition that is detected
• possible causes of the condition (where applicable)
• configurable set point that controls when alarm becomes active (where applicable), and
section where such configuration is discussed
• relay which alarm activates
*
All Legacy Alarms will activate the Common Alarm relay (as discussed in Section
9.2), thereby changing to the alarmed state after a configured time delay.
Alarms will also be reported by any installed optional protocol communications board and may
Copyright HindlePower Inc. 2021
ATevo Operations–Single Phase Input–Group II (30-100 Adc Output) - 1_en
SECTION TOPICS SECTION TOPICS
Legacy Alarms & Indicators
Common Alarm Indicator & Other Alarm Triggers

Alarm LED Summary Table

Viewing Alarms

Viewing Alarms
Advanced Alarms
Resetting Latched Alarm Relays
Battery Open Test
Section 9.3.
Last modified: 17 May 2021
Page 95 of 171