Auxiliary Inputs/Outputs Auxiliary Inputs/Outputs; Auxiliary Input/Output (I/O) Board; Connections To Auxiliary I/O Board; Software Configuration For Analog Inputs - HindlePower ATevo Series Operations

HindlePower Inc
14. 14. Auxiliary Inputs/Outputs Auxiliary Inputs/Outputs
14.1.

14.1. Auxiliary Input/Output (I/O) Board

Auxiliary Input/Output (I/O) Board
The Auxiliary I/O Board (A4) is an optional component that mounts near the top of the heat sink
on the left side of the ATevo . It is equipped with six (6) relays, four (4) generic Binary Inputs,
and four (4) generic Analog Inputs.
The Auxiliary I/O Board (A4) communicates to the Main Control Board (A1) via serial
communications. The Serial Communications Connection is part of the ribbon cable between
the Main Control Board and the Power Board (A2). A green communications LED is located
adjacent to the TB2 terminal block of the Auxiliary I/O Board.
This LED will blink to indicate active communication between the Auxiliary I/O Board and the
Main Control Board. All relays are failsafe such that if communication is lost between the Main
Control Board (A1) and the Auxiliary I/O Board (A4), the relays will switch to the alarm state.
Copyright HindlePower Inc. 2021
ATevo Operations–Single Phase Input–Group II (30-100 Adc Output) - 1_en
SECTION TOPICS SECTION TOPICS
Auxiliary Input/Output (I/O) Board

Connections to Auxiliary I/O Board

Hardware Configuration
Software Configuration for Relays
Software Configuration for Binary Inputs

Software Configuration for Analog Inputs

Last modified: 3 March 2021
Page 124 of 171