HindlePower ATevo Series Operations page 57

HindlePower Inc
https://www.youtube.com/embed/VjuwjKU7Kt4?rel=0&start=6&end=62
https://www.youtube.com/embed/VjuwjKU7Kt4?rel=0&start=39&end=82
https://www.youtube.com/embed/VjuwjKU7Kt4?rel=0&start=39&end=82
https://www.youtube.com/embed/VjuwjKU7Kt4?rel=0&start=107&end=185
Instructions with Screenshots Instructions with Screenshots
When you first press EDIT/ENTER on the front panel, ATevo prompts you to set the first of six (6)
basic charger parameters (Float Voltage). Once you have done so, and press EDIT/ENTER again,
the next parameter will appear automatically. Continue in this same manner until you have set
all the parameters.
To adjust the value of a basic charger set point, do the following:
• Press UP or DOWN (or hold down to scroll) until desired value displays. Each parameter
has a minimum and maximum limit as listed in
• Press EDIT/ENTER to save setting. ATevo prompts you to set the next parameter.
• Continue in the same manner to set all six (6) parameters in the list. If you want to skip
setting any parameter, press EDIT/ENTER (or RIGHT arrow) to bypass it.
Copyright HindlePower Inc. 2021
ATevo Operations–Single Phase Input–Group II (30-100 Adc Output) - 1_en
Section 6.1.2, Factory Settings Tables.
Page 55 of 171