HindlePower ATevo Series Operations page 29

HindlePower Inc
A22-Ether A22-Ethernet Communications A net Communications Adapter – optional
Shown directly to bottom-left of Main Control Board (A1) on silkscreen. Plugs into Main Board at
P13. Supports DNP3 and Modbus protocols via 10/100 copper Ethernet connection.
C2-Eliminator F C2-Eliminator Filter Capacitor – optional ilter Capacitor – optional
Shown below Power Board on silkscreen. Mounted on bottom-left under Power Board. Provides
the additional ripple filtering required for the 'filtered eliminator' option.
CB1- CB1-A A C Input Cir C Input Circuit Br cuit Break
Located in center of ATevo, about one third from bottom. Protects ATevo ac wiring, and can be
used to disconnect from its ac source.
CB2-DC Output Cir CB2-DC Output Circuit Br cuit Break
Located at bottom-center below AC breaker. Protects ATevo dc wiring, and can be used to
disconnect ATevo from battery and system dc load(s).
L1-Main F L1-Main Filter Inductor ilter Inductor
Shown in center of silkscreen. Located on bottom-left of back wall. It is part of the dc filter,
lowering ripple
L2-Secondary F L2-Secondary Filter Inductor ilter Inductor
Shown bottom-center of silkscreen. Located on bottom of back wall to right of Filter Inductor
(L1). It is also part of the dc filter.
T1-P T1-Power Isolation T ower Isolation Transfor ransformer
Shown near center of silkscreen. Located on back wall above the filter inductors (L1/L2).
Provides isolation and converts ac input voltage to appropriate potential prior to rectification.
4.2. 4.2. Mechanical Diagram (75-100 Adc) Mechanical Diagram (75-100 Adc)
The Single Phase Input, Group II ATevo which has an output range of 75-100 Adc has the
following mechanical layout and wiring diagram screen-printed onto its patented, internal
protective Plexiglas shield.
Copyright HindlePower Inc. 2021
ATevo Operations–Single Phase Input–Group II (30-100 Adc Output) - 1_en
dapter – optional
eaker er
eaker er
mer
Last modified: 11 May 2021
Page 27 of 171