HindlePower ATevo Series Operations page 37

HindlePower Inc
I/O Connections (Style-5070) I/O Connections (Style-5070)
1. Use a dc disconnect switch or circuit breaker between ATevo and the dc bus. This
device should have lockout capability to allow ATevo to be disconnected from the dc
bus for maintenance.
2. Remove safety shield per
3. Run dc wiring into ATevo, ending at right side of I/O panel.
4. Connect wires to appropriate dc output CU-AL compression lugs on right side of I/O
panel.
!
To prevent equipment damage, confirm polarity of pos(+) and neg(-) wiring.
5. Using a flat-blade screwdriver, securely tighten lugs for pos(+) and neg(-)
connections.
6. Check all dc output connections, and reinstall safety shield.
Copyright HindlePower Inc. 2021
ATevo Operations–Single Phase Input–Group II (30-100 Adc Output) - 1_en
Removing Protective Safety Shield in Section 4.
Page 35 of 171