Changing Charge Mode - HindlePower ATevo Series Operations
Float battery charger phase input–group ii (30-100 adc output)
Hide thumbs
Also See for ATevo Series:
- Operating/service instructions manual (164 pages) ,
- Operating/service instructions manual (311 pages) ,
- Operating/service instructions manual (316 pages)
Table of Contents
Advertisement
HindlePower Inc
• DC Voltage and DC Amperes
• DC Amperes (only)
• DC Voltage (only)
• Time and Date
To change Display Mode:
DISPLAY MODE > one of 4 displayed choices
*
The DISPLAY MODE button is in the same relative location as the METER MODE
button on legacy ATevo chargers. Its functionality is equivalent in that it
determines which measurements are to be shown on the HOME screen.
7.1.2.
7.1.2. Changing Charge Mode
Changing Charge Mode
https://www.youtube.com/embed//_6nyTznWz6k?rel=0&start=7
ATevo has two (2) output voltage modes that are set with the CHARGE MODE button:
• FLOAT – for normal battery charging
• EQUALIZE – to balance voltage among battery cells. Before using, consult your battery
manufacturer's data sheets.
Present charge mode is displayed at the top left of the HOME screen:
'Float' appears when charger is in FLOAT mode; 'Equalize' appears when it is in EQUALIZE
mode.
To change Charge Mode:
CHARGE MODE > other displayed choice
Copyright HindlePower Inc. 2021
ATevo Operations–Single Phase Input–Group II (30-100 Adc Output) - 1_en
Last modified: 11 February 2021
Page 70 of 171
Advertisement
Table of Contents
