HindlePower ATevo Series Operations page 141

HindlePower Inc
To assign a control to a binary input:
MENU > AUX INPUTS > 'Binary Input Configuration' > select input from options (as shown
above) > 'Action:' > select from 2 actions
*
Midway through 2021, ATevo chargers began shipping with firmware v2.7.0
which includes a new action called "Disable Equalize" which is described
further in the Appendix topic, Firmware v2.7.0 Enhancements.
14.6. 14.6. Software Configuration for Analog Software Configuration for Analog
Inputs Inputs
The Auxiliary I/O Board analog inputs are used to monitor, alarm, and/or report on the status of
any external transducer or sensor. Each input can be scaled such that the value is reported in
primary units (°C, Vac, etc.).
The analog inputs can also generate alarms when their reported values are below, above, or
out-of-range of a configured valued. ATevo assigns each input a unique generic name that may
be replaced by the user.
*
Software Configuration Naming: In the following subsections, Auxiliary I/O Board
analog inputs' default names are specified by board number (see Section 14.3),
and analog input number on the associated board. For example: 'Aux 1 input
AN2'
specifies analog input #2 on Auxiliary I/O Board #1.
Unless otherwise specified, the ATevo Auxiliary I/O Board (A4) will ship from the factory with the
following analog input configuration:
Copyright HindlePower Inc. 2021
ATevo Operations–Single Phase Input–Group II (30-100 Adc Output) - 1_en
F F actory Default Analog Input Configuration actory Default Analog Input Configuration
Last modified: 17 May 2021
Page 139 of 171