HindlePower ATevo Series Operations page 54

HindlePower Inc
End of Dischar End of Discharge ge
A A C Ripple Alar C Ripple Alarm m
Gr Ground F ound Fault ault POS POS 10
Ground F Gr ound Fault ault NEG NEG 10
260 V 260 Volt Char olt Charger Set P ger Set Points & Defaults
P P arameter arameter
Float V Float Voltage oltage
Equalize V Equalize Voltage oltage
Curr r ent Limit Cur ent Limit
Equalize T Equalize Time ime
High VDC High VDC Alar Alarm m
L L ow ow VDC VDC Alar Alarm m
HVDC HVDC Shutdown Shutdown
High Level Detect High L evel Detect 240.0
L L ow L ow Level Detect evel Detect
End of Discharge End of Dischar ge
A A C Ripple Alar C Ripple Alarm m
Gr Ground F ound Fault ault POS POS 10
Gr Ground F ound Fault ault NEG NEG 10
6.1.3. 6.1.3. Checking Installation Checking Installation
Prior to powering up ATevo for the first time, it is recommended that:
• You have followed installation instructions carefully.
• You check that ac input supply voltage and battery voltage match information on ATevo
nameplate.
• Open the front panel, and check battery polarity at the DC Output Circuit Breaker (CB2+/-
).
Copyright HindlePower Inc. 2021
ATevo Operations–Single Phase Input–Group II (30-100 Adc Output) - 1_en
87.0
20
oints & Defaults
L L ow R ow Range Set P ange Set Point oint High R
220.0
234
50% rating
0.1
240.0
140.0
240.0
177.0
177.0
20
120.0
250
40
40
High Range Set P ange Set Point oint Nominal (Default)
282.0
298.0
110% rating
99.0
288.0
282.0
288.0
288.0
244.0
244.0
250
40
40
105.0 volts
70 millivolts
15 kiloohms
15 kiloohms
Nominal (Default) Units Units
262.0 volts
278.0 volts
110% rating amperes
24.0 hours
350.0 volts
240.0 volts
350.0 volts
350.0 volts
210.0 volts
210.0 volts
70 millivolts
15 kiloohms
15 kiloohms
Last modified: 10 February 2021
Last modified: 4 May 2021
Page 52 of 171