HindlePower ATevo Series Operations page 138

HindlePower Inc
F F actory Default Alar actory Default Alarm R m Relay Configuration
Unless otherwise specified, the ATevo Auxiliary I/O Board (A4) will ship from the factory
with the following Alarm Relay Configuration:
14.5. 14.5. Software Configuration for Binary Software Configuration for Binary
Inputs Inputs
The Auxiliary I/O Board (A4) binary inputs are used to monitor, alarm, and/or report on the
status of any external switch or contact. Each input can be independently configured to be
active high or low, activate an alarm, and/or activate a control. ATevo assigns each input a
unique generic name that may be replaced by the user.
*
Software Configuration Naming: In the following subsections, Auxiliary I/O Board
binary inputs default names are specified by board number (see Section 13.3),
and binary input number on the associated board. For example: 'Aux 1 input B2'
specifies binary input #2 on Auxiliary I/O Board #1.
Unless otherwise specified, the ATevo Auxiliary I/O Board (A4) will ship from the factory with the
following binary input configuration:
Copyright HindlePower Inc. 2021
ATevo Operations–Single Phase Input–Group II (30-100 Adc Output) - 1_en
elay Configuration
F F actory Default Alar actory Default Alarm R
R R elay elay Name Name
. #1 High DC Voltade
. #2 Low DC Voltade
. #3 DC Output Failure
. #4 Low AC Supply
. #5 Positive Ground Fault
. #6 Negative Ground Fault disabled 30 seconds
F F actory Default Binary Input Configuration actory Default Binary Input Configuration
Binary Input Binary Input Name Name Alar
1. BI1-1
2. BI1-2
m Relay Configuration elay Configuration
Latching Delay Latching
disabled 30 seconds
disabled 30 seconds
disabled 30 seconds
disabled 30 seconds
disabled 30 seconds
Alarm State m State A A ction ction A A ctive State
disabled none
disabled none
Delay
Last modified: 18 July 2022
ctive State
high
high
Page 136 of 171