HindlePower ATevo Series Operations page 81

HindlePower Inc
Copyright HindlePower Inc. 2021
ATevo Operations–Single Phase Input–Group II (30-100 Adc Output) - 1_en
Used to configure Binary Inputs and Analog Inputs for up to
four (4) Auxiliary I/O Boards. Each board may have up to
four (4) generic Binary Inputs and four (4) generic Analog
Inputs. See Section 14.5
for Analog.
Displays the Battery Open Test configuration and controls.
See Section 9.7 for instructions on how to start, schedule,
and set up parameters for the Battery Open Test.
Used to configure optional communications ports. ATevo
supports three serial communications ports and one
Ethernet port. It shows all communications ports, and
whether or not they are assigned and configured. Two (2) of
the serial ports support DNP3 and Modbus communications.
Refer to the supplementary
for port configuration instructions.
for Binary Inputs, and
ATevo Communications Manual
Section 14.6
Page 79 of 171