HindlePower ATevo Series Operations page 13

HindlePower Inc
Remove all jewelry, watches, rings, etc. before proceeding with installation or servicing
to avoid electrical shock hazards.
Do not operate ATevo with any power source that does not match the specified ac and
dc voltage ratings. Refer to the data nameplate decal affixed to the outside panel for
operational requirements.
Do not operate ATevo with the safety shield or any other supplied guards removed or
improperly installed.
Do not operate ATevo if it has been damaged in any way. Refer to qualified service
personnel.
Before using ATevo, read all instructions and cautionary
markings on: a) this equipment, b) battery, and c) any other equipment to be used in
conjunction with ATevo
Do not use ATevo for ANY purpose not described in this manual.
Turn OFF ATevo before connecting or disconnecting the battery to avoid electrical shock
hazards, arcing, burning, and/or equipment damage.
De-energize and lock out all ac and dc power sources to ATevo before servicing.
Do not disassemble ATevo. Only qualified service personnel should attempt repairs.
Incorrect reassembly could result in explosion, electrical shock or fire.
2.5. 2.5. CAUTIONS CAUTIONS
!
Potentially hazardous situation, which if not avoided, could result in minor or
moderate injury (e.g. minor burns, bruising from pinch points, minor chemical
irritation). May also be used to alert against unsafe practices.
Copyright HindlePower Inc. 2021
ATevo Operations–Single Phase Input–Group II (30-100 Adc Output) - 1_en
Last modified: 3 May 2021
Page 11 of 171