HindlePower ATevo Series Operations page 89

HindlePower Inc
to a file named ATgvai00.EVO where:
• 'g' specifies charger family: (1) <= 25A,( 2) > 25A, (3) = 3 phase.
• 'v' specifies dc voltage: (A) = 12V, (B)= 24V, © = 48V, (D) = 130V, (E) = 260V.
• 'a' specifies dc current: (A) = 6A, (B) = 12 A, © = 16A, (D) = 20A, (E) = 25A.
• 'i' specifies charger ID (A-Z): per SYSTEM INFO menu.
You may use this saved configuration file to:
• Restore configuration in case someone inadvertently changes a setting and doesn't
remember the original setting.
• Clone configuration to a similar charger to eliminate need to set up parameters manually.
• Configure a replacement Main Control Board (A1) automatically.
To copy ATevo Configuration from SD Memory Card to the Main Control Board (A1):
MENU > SAVE:RESET SETTINGS >'Restore from Memory Card'
The screen will briefly confirm the file was copied successfully. The charger will restart with the
restored configuration settings.
8.5.4. 8.5.4. Upgrading Firmware via Memory Upgrading Firmware via Memory
Card (v2.6.6 & earlier) Card (v2.6.6 & earlier)
A powerful ATevo charger feature is that the Main Control Board (A1) firmware (or software) can
be easily updated in the field without uninstalling the charger or any boards. The process takes
minutes.
The first step in upgrading ATevo is to obtain the latest two (2) program files from the supplier:
• mainapp.bin = Main Control Application program
• bruno.bin = Display Application program
Copyright HindlePower Inc. 2021
ATevo Operations–Single Phase Input–Group II (30-100 Adc Output) - 1_en
Last modified: 11 February 2021
Page 87 of 171