HindlePower ATevo Series Operations page 117
Float battery charger phase input–group ii (30-100 adc output)
Hide thumbs
Also See for ATevo Series:
- Operating/service instructions manual (164 pages) ,
- Operating/service instructions manual (311 pages) ,
- Operating/service instructions manual (316 pages)
Table of Contents
Advertisement
HindlePower Inc
• Route TempCo cable to lower end of Power Board (A2).
• Locate TB8 and insert one (1) of each of the stripped wires from the twisted pair into each
location on the terminal block (A2-TB8). Connection Points are not polarity sensitive.
• Locate the EARTH quick-connect terminal at the bottom of Power Board (A2). Carefully
pull off the quick-connect terminal and wire from the EARTH terminal.
• Plug the quick-connect terminal attached to the end of the TempCo cable's shield wire
Copyright HindlePower Inc. 2021
ATevo Operations–Single Phase Input–Group II (30-100 Adc Output) - 1_en
Page 115 of 171
Advertisement
Table of Contents
