HindlePower ATevo Series Operations page 52

HindlePower Inc
chargers.
6.1.1. 6.1.1. Understanding the Startup Understanding the Startup
Sequence Sequence
ATevo is pre-configured to work with most common batteries and loads without further
adjustment.
When you start ATevo for the first time, the charger will:
• Use the FACTORY SETTINGS
tables. These settings may be changed after startup if necessary.
• Take about 15 seconds to start. Control circuitry will "soft start" ATevo, such that DC
output voltage and current increase gradually to rated values.
6.1.2. 6.1.2. Factory Settings Tables Factory Settings Tables
Factory settings for each ATevo are summarized below. Click to expand the toggle to see the
table.
24 V 24 Volt Char olt Charger Set P ger Set Points & Defaults
P P arameter arameter
Float V Float Voltage oltage
Equalize V Equalize Voltage oltage
Curr r ent Limit Cur ent Limit
Equalize Time Equalize T ime
High High VDC VDC Alar Alarm m
L L ow ow VDC VDC Alar Alarm m
HVDC Shutdown HVDC Shutdown
High L High Level Detect evel Detect 24.0
L L ow L ow Level Detect evel Detect
End of Dischar End of Discharge ge
A A C Ripple Alar C Ripple Alarm m
Copyright HindlePower Inc. 2021
(float voltage, equalize voltage, etc) listed in the following
oints & Defaults
L L ow R ow Range Set P ange Set Point oint High R
22.0
23.4
50% rating
0.1
24.0
14.0
24.0
15.0
15.0
20
ATevo Operations–Single Phase Input–Group II (30-100 Adc Output) - 1_en
High Range Set P ange Set Point oint Nominal (Default)
29.5
32.0
110% rating
99.0
38.0
25.0
38.0
38.0
24.0
24.0
250
Last modified: 10 March 2021
Last modified: 10 February 2021
Nominal (Default) Units Units
26.0 volts
28.0 volts
110% rating amperes
24.0 hours
28.8 volts
24.0 volts
28.8 volts
28.8 volts
21.0 volts
21.0 volts
20 millivolts
Page 50 of 171