HindlePower ATevo Series Operations page 28

HindlePower Inc
Click on the name of any individual component for detailed information and a close-up view:
A1-Main Contr A1-Main Control Boar ol Board d
Shown on top-right of silkscreen. Mounted on the ATevo front panel door. Contains display,
buttons, alarm indicators, and is responsible for battery charger controls.
A2-P A2-Power Boar ower Board d
Shown on bottom-left of silkscreen. Mounted on heat sink along left side of ATevo. Contains
most power electronic connections, and terminal blocks for remote sense and battery
temperature compensation options.
A4- A4-Auxiliary I/O Boar Auxiliary I/O Board – optional d – optional
Shown at top-left of silkscreen. Bolted to heat sink on the left side, above the Power Board.
Plugs directly into Power Board (A2).
• six (6) relays, four (4) Binary Inputs, and four (4) Analog Inputs
• relays can be configured to indicate status of six (6) different alarms or status points
• independently-isolated Binary Inputs can be configured to report ON/OFF status of
four (4) controls
• Analog Inputs include input scaling and can report the status of four (4) analog
controls referenced to the dc bus
A7-F A7-Filter Capacitor Boar ilter Capacitor Board or C1x-Capacitors
The electrolytic capacitors (C1x) filter 'ripple' from the dc output. ATevo units rated 30-50A
utilize a Capacitor Board (A7) bolted to the top of the Power Board (A2). ATevo units rated
75-100A utilize a bank of discrete capacitors (C1x), hardwired to the Power Board (A2) with
bolted connections.
A9- A9-A A C Sur C Surge Suppr ge Suppressor essor MO
Shown to left of AC Circuit Breaker (CB1) on silkscreen. Mounted to top-left side of breaker
bracket. Contains ac input surge suppression and filtering. It is located for easy access,
examination, and replacement in case an input transient event should occur.
A10-R A10-Remote T emote Temperatur emperature P
The battery temperature compensation, or 'TempCo', probe (A10) contains a temperature-
dependent resistor in an epoxy module. When used, this probe is installed on the battery and is
connected to the Power Board (A2) at TB8.
A12-Serial Communications A A12-Serial Communications Adapter
Shown above Ethernet Comm. Adapter (A22) on silkscreen. Up to three (3) Serial
Communications Adapter boards (A12) can be plugged into the Main Control Board (A1) at
locations P10, P11, and P12. This option supports DNP3 and Modbus protocols, and can be
configured to support 2-wire or 4-wire RS-232 connections, or 2-wire or 4-wire RS-485
connections.
A13-F A13-For orced L ced Load Sharing Communications A oad Sharing Communications Adapter – optional
Mounted similarly to Serial Communications Adapter (A12).
Copyright HindlePower Inc. 2021
ATevo Operations–Single Phase Input–Group II (30-100 Adc Output) - 1_en
d or C1x-Capacitors
MOV V Boar Board d
e Pr r obe – optional obe – optional
dapter
dapter – optional
Page 26 of 171