HindlePower ATevo Series Operations page 32

HindlePower Inc
T1-P T1-Power Isolation T ower Isolation Transfor ransformer
Shown near center of silkscreen. Located on back wall above the filter inductors (L1/L2).
Provides isolation and converts ac input voltage to appropriate potential prior to rectification.
4.3. 4.3. Removing Protective Safety Shield Removing Protective Safety Shield
To prevent injuries, the ATevo safety shield must always be installed when
charger is in operation and/or energized.
Style-5054 Enclosure Instructions Style-5054 Enclosure Instructions
• A standard flat blade screwdriver is required.
• Open the ATevo front panel door to access safety shield.
• Remove the two (2) screws that attach the safety shield to the ATevo, one above AC Input
Breaker (CB1), the other below theDC Output Breaker (CB2).
• Grab the safety shield on both left and right sides, and gently lift up and off of AC Input
and DC Output Circuit Breakers.
• Reverse procedure for reinstalling the safety shield.
Style-5070 Enclosure Instructions Style-5070 Enclosure Instructions
• Standard Phillips head screwdriver is required.
• Open ATevo front panel door to access safety shield.
• Remove four (4) screws from corners of top shield and (4) screws from corners of bottom
shield.
• Grab the safety shield while removing the last screw, and gently remove.
• Reverse procedure for reinstalling the safety shield.
4.4. 4.4. Retapping Power Isolation Retapping Power Isolation
Transformer Transformer
Group II (30-100Adc) ATevos do not feature a mulit-tap input terminal block for the Power
Isolation Transformer (T1). However, transformers in certain models can be retapped in the
field to switch between connected input voltages.
Copyright HindlePower Inc. 2021
ATevo Operations–Single Phase Input–Group II (30-100 Adc Output) - 1_en
mer
See Service Instruction
Last modified: 22 February 2022
Last modified: 11 May 2021
Last modified: 4 May 2021
JD5026-52.
Page 30 of 171