Korg KRONOS SGX-2 Parameter Manual page 137

Envelope Latch [Off, Sus1, Rel1, Sus2, Rel2]
Off: The envelope will not be latched. When all keys are
released or a Dynamic MIDI trigger is released (note-off),
the envelope will move to the release segment.
Sus1: Once the envelope is started, it will proceed through
attack decay sustain
before the envelope reaches the sustain level, the envelope
will not begin the release immediately but wait until after
reaching the sustain level. Even in the case of a note for
which the note-on/off interval is short, the envelope will
proceed through attack decay
the key was being held for a longer time. If the envelope
reaches the sustain level before receiving note-off, it will
hold at the sustain level (the same operation as for the Off
setting). If the note-off occurs after the envelope reaches the
sustain level, the envelope will begin the release when note-
off occurs (the same operation as for the Off setting).
Rel1: Once the envelope has started, it will proceed through
attack decay release, regardless of when the note-off
occurs. Even if a key is being pressed, the envelope will
ignore sustain, and will proceed immediately to the release.
Sus2: The envelope will ignore note-off, and will proceed
through attach decay sustain. Therefore, this setting
will never reach the release portion. Other operation is the
same as for Sus1.
Rel2: The same operation as Rel1, except will ignore note-
off for the purpose of looping, as explained below.
The envelope can be set to repeat as a loop as part of the GE.
A looped envelope will be controlled as follows.
For Sus1 and Rel1, the envelope will continue repeating as
long as the key is held.
For Sus2 and Rel2, the envelope will continue repeating
even if the key is released.
v 7-4: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 153.
• 0: Write Program. For more information, see "Write
Program" on page 153.
• 1: Exclusive Solo. For more information, see "Exclusive
Solo" on page 153.
• 2: Copy KARMA Module. For more information, see
"Copy KARMA Module" on page 162.
• 3: Initialize KARMA Module. For more information,
see "Initialize KARMA Module" on page 163.
• 4: Copy Scene. For more information, see "Copy Scene"
on page 164.
• 5: Swap Scenes. For more information, see "Swap
Scene" on page 164.
• 6: Capture Random Seed. For more information, see
"Capture Random Seed" on page 164.
release. If note-off occurs
sustain release as if
Program P7: KARMA 7–4: Module Parameters-Trigger
123