Installing The Gearbox - Skoda FABIA II 2007 Workshop Manual

FABIA II 2011 ➤
Automatic gearbox 0AM - Edition 02.10
If necessary, remove the bracket at the front of the gearbox.
Note
If a "new" gearbox must be installed, the brackets must be fitted
to the "new" gearbox.
– Install the right flange shaft again
Tightening torque 30 Nm
Transporting the gearbox and secure to the assembly support
⇒ page 83 .

Installing the gearbox

⇒ page 80
4.2 Installing the gearbox
Installation is performed in the reverse order, pay attention to the
following points:
Note
When performing installation work replace the self-locking
♦
nuts and screws ⇒ Electronic Catalogue of Original Parts .
Replace screws which have been tightened to a torquing an‐
♦
gle, as well as gasket rings and gaskets ⇒ Electronic Cata‐
logue of Original Parts .
Secure all hose connections with hose clamps which comply
♦
with the series design ⇒ Electronic Catalogue of Original
Parts .
All cable straps which are detached or cut open when remov‐
♦
ing, should be fitted on again in the same place when installing.
The lock washer of the selector lever control cable must al‐
♦
ways be replaced ⇒ Electronic Catalogue of Original Parts .
Replace the needle bearing -arrow- in the crankshaft ⇒ En‐
♦
gine ⇒ Rep. Gr. 13 .
Remove the right flange shaft before installing the gearbox
♦
⇒ page 91 .
Check whether the dowel sleeves for centering the gearbox
♦
are present in the cylinder block, insert if necessary.
If the gearbox is inserted, ensure the intermediate plate be‐
♦
tween the engine and gearbox is correctly installed.
80
Rep. Gr.34 - Control, housing
⇒ page 91 .
.