Setting Output Shaft - Skoda FABIA II 2007 Workshop Manual

Press on the synchronizer body with the 3rd and 4th gear sliding
sleeve
Pressing on bushing for 4th gear needle bearing
– Install needle bearing, 4th gear sliding gear and synchronizer
ring.
– Place thrust washer
gear.
Pressing on bushing for needle bearing/output shaft -A-
2.2

Setting output shaft

(Determine adjusting washer for drive shaft)
Special tools and workshop equipment required
♦ Gauge block plate -MP3-405/17-
♦ Drive bushing -MP3-423 (VW 407)-
♦ Universal dial gauge holder -MP3-447 (VW 387)-
♦ Thrust plate -MP3-460 (VW 512)-
♦ Bolts M8 and M10 -3114/2-
♦ Interior extractor 37...46 mm , e.g. -Kukko 21/6-
♦ Countersupport e.g. -Kukko 22/2-
♦ Dial gauge
The output shaft must be re-set when the following components
are replaced:
♦ Output shaft
♦ Clutch housing
⇒ Item 33 (page 134) on 4th gear sliding
FABIA II 2007 ➤
Gearbox 02R - Edition 12.06
2. Output shaft
141