Working With Testing Devices - Skoda FABIA II 2007 Workshop Manual

FABIA II 2011 ➤
Automatic gearbox 0AM - Edition 02.10
The "targeted fault finding" is performed with the ⇒ Vehicle diag‐
nosis, testing and information system VAS 5051.
Rules of cleanliness
♦ Thoroughly clean the connection points and their surroundings
before releasing.
♦ Only install clean parts: Remove spare parts from their wrap‐
ping immediately before installing.
♦ Place removed parts on a clean surface and cover, so that
they are not clogged up with dirt. Use foil and paper. Do not
use fuzzy cloths!
♦ Carefully cover or close opened components if the repair is not
completed immediately.
2.3

Working with testing devices

♦ Vehicle diagnosis, measurement and information system -
VAS 5052 A-
♦ Vehicle diagnosis, measurement and information system -
VAS 5051B-
Work in the operating modes
geted fault finding
2.3.1 Adapt information regarding lining
The mechatronics detects the other control units in the vehicle via
the signals in the CAN databus. If the key
is pressed, the mechatronics receives a
regarding lining
command to forget all systems with which it can communicate.
However, after switching on the ignition all "active systems" with
which it can communicate are detected.
No faults can be "generated" with this function. The function
adapt information regarding lining
after the following operations:
♦ After installing the mechatronics.
♦ After the gearbox has been fitted.
♦ After installing the selector lever.
♦ After installing a different control unit, for example of the en‐
gine, ABS or Gateway.
2.3.2 Perform basic setting
The mechatronics memorises important settings in the function
COMPLETE BASIC SETTING
memorised, e.g reset to preprogrammed points. For example
among others, the synchronisation points and the "vertices" for
the engaging lever and the gear switch.
– Button
COMPLETE BASIC SETTING
♦ after interrogating with "targeted fault finding"
♦ after rectifying the fault displayed in the fault memory
♦ or after installing the clutch
8
Rep. Gr.00 - Technical data
targeted functions
.
adapt information
is always carried out
. The important settings are also
only functions:
and
tar-