Skoda FABIA II 2007 Workshop Manual page 841

FABIA II 2007 ➤
Gearbox 02T - Edition 12.06
Press on the inner ring -A- for the cylindrical-roller bearing
– Insert the circlip.
Determining the circlip thickness
– Insert circlip with a thickness of 2.0 mm in the slot of the drive
shaft and push upwards.
– Measure the dimension between the inner ring of the taper
roller bearing and the positioned circlip using a feeler gauge.
– Remove the circlip used to take the measurement.
– Determine thickness of circlip according to the table.
Note
Assign the circlips via the ⇒ Electronic catalogue of original parts .
The following circlips are available:
Measured value
(mm)
0,05...0,14
0,15...0,24
0,25...0,34
0,35...0,44
0,45...0,51
Press on the bearing support for grooved ball bearing
– Before pressing on the bearing support heat it to approximate‐
ly 100 °C.
114
Rep. Gr.35 - Wheels, shafts
Circlip thickness Axial play (mm)
(mm)
2,0
2,1
2,2
2,3
2,4
0,05...0,15
0,05...0,15
0,05...0,15
0,05...0,15
0,05...0,10