Removing And Installing Switch Units For Gearbox Operation In Tiptronic Mode (Gearbox 02E, 0Am - Dsg) - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
Electrical system - Edition 12.2014
– Remove bolts -3- (0.4 Nm).
– When removing modules -1- and -2-, carefully loosen the con‐
nection cable from the bracket -arrows-.
– Vehicles with automatic transmission with column gear shift –
separate plug connections from switch units.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
Note
Install connection cable for modules correctly in the line in the
♦
plate -arrows-.
Before the airbag is installed, it must be checked if all the wiring
♦
is properly pressed back into the guiding grooves in the steer‐
ing wheel foam. Wiring which protrudes can be damaged by
the backside parts of the airbag.
Pay attention to the work sequence when connecting the bat‐
♦
tery
⇒ "2.3 Work sequence when disconnecting and connecting
the battery", page 2 .
– Perform coding with ⇒ Vehicle diagnostic tester when replac‐
ing the switch units.
4.3 Removing and installing switch units for
gearbox operation in Tiptronic mode
(gearbox 02E, 0AM – DSG)
The mounting sequence is identical for both switch units.
Removing
– Remove the airbag unit in the steering wheel ⇒ Body Work;
Rep. gr. 69 .
– Prise out the plate with switch units -2- evenly and carefully
out of the steering wheel -1- using the disassembly wedge
-arrows-.
– Disconnect plug.
48
Rep. gr.91 - Communication