Repairing Clutch Control - Skoda FABIA II 2007 Workshop Manual

2

Repairing clutch control

Special tools and workshop equipment required
♦ Grease for the plug serration of the clutch disc -G 000 100-
♦ Sealing grease -G 052 128 A1-
1 - Gearbox
2 - Ball stud, 25 Nm
❑ remove previous grease
from the contact surface
of the release lever
❑ grease with grease for
plug serration of clutch
disc -G 000 100-
3 - Gasket ring for drive shaft
❑ fitted in guide bushing
Pos. 4
❑ replace ⇒ page 108
❑ Fill half the space be‐
tween the sealing lips
and dust lips with seal‐
ing grease -G 052 128
A1-
4 - Guide bushing
❑ with vulcanized O-ring
❑ if O-ring is damaged, re‐
place guide bushing to‐
gether with O-ring
⇒ page 108
❑ for removal, remove
clutch release lever
Pos. 7
❑ grease in the area of the
clutch release lever with
grease for plug serration
of clutch disc -
G 000 100-
5 - Retaining spring
❑ attach to clutch release
lever
6 - 20 Nm
7 - Clutch release lever
❑ remove and install
❑ remove previous grease from the contact surface of the clutch release lever
❑ Grease contact surface on the ball stud with grease for plug serration of clutch disc -G 000 100-
8 - Release bearing
❑ Do not wash the bearing, just wipe clean
❑ replace noisy bearings
❑ removing and installing
❑ Grease contact surface on the clutch release lever with grease for plug serration of clutch disc -G 000 100-
9 - Slave cylinder
❑ removing and installing
❑ Grease tappet head with grease for plug serration of clutch disc -G 000 100-
⇒ page 38 together with clutch release bearing Pos. 8
⇒ page 38
⇒ page 33
FABIA II 2007 ➤
Gearbox 02R - Edition 12.06
2. Repairing clutch control
37