Removing And Installing The Master Cylinder; Fabia Ii - Skoda FABIA II 2007 Workshop Manual

FABIA II 2007 ➤
Gearbox 02R - Edition 12.06
– Unscrew the nuts -arrows 1- and remove the bracket
-arrow A- together with the master cylinder.
– Unscrew pedal stop
– Remove the master cylinder.
Install
Installation is performed in the reverse order, pay attention to the
following points:
– Insert the bearing for over-centre helper spring in the bracket.
– The support -A- must be located on the actuating rod -B- of
the master cylinder.
– To click in the support -A-, press the clutch pedal towards the
front wall in -direction of arrow-. While doing so, make sure it
catches correctly in the support.
– Install the clutch pedal switch -F36-
– Install crash strut (if present)
– Install the storage area on the driver's side ⇒ Body Work ⇒
Rep. Gr. 70 .
– After installing the master cylinder bleed the clutch control
⇒ page 35 .
Tightening torques
Bracket/clutch pedal to front wall
Master cylinder to front wall
Clutch pedal to bracket
1)
Replace self-locking nut.
1.13 Removing and installing the master cyl‐
inder; Fabia II 2011 ?
Special tools and workshop equipment required
♦ Pliers -T10005-
♦ Polycarbamide grease -G 052 142 A2-
Removing
Remove bracket with master cylinder
32
Rep. Gr.30 - Clutch
⇒ Item 19 (page 10) .
⇒ Item 7 (page 9)
⇒ page 12 .
1)
1)
1)
⇒ page 18
.
⇒ Item 6 (page 9)
⇒ Item 13 (page 10)
⇒ Item 20 (page 10)
.