Gearshift Forks; Mounting Sequence - Skoda FABIA II 2007 Workshop Manual

FABIA II 2007 ➤
Gearbox 02T - Edition 12.06
12 - 5 Nm + torque a further 90°
❑ always replace ⇒ Electronic Catalogue of Original Parts
13 - Reversing light switch - F4- , 20 Nm
14 - Gasket ring
❑ if present, replace ⇒ Electronic Catalogue of Original Parts
15 - Shift mechanism

❑ Gearshift forks

❑ disassembling and assembling
16 - Drive shaft and output shaft with bearing support for grooved ball bearing
❑ Always replace bearing support after removing ⇒ Electronic Catalogue of Original Parts
❑ pressing off and on bearing support
❑ Disassembling and assembling the drive shaft
❑ Disassembling and assembling the output shaft
17 - Reverse shaft support
❑ with support
18 - Reverse gear wheel
19 - Screw
❑ for reverse shaft support Pos. 17
❑ M6: 5 Nm + torque a further 90°
❑ M8: 25 Nm + torque a further 45°
❑ always replace ⇒ Electronic Catalogue of Original Parts
4.6

Mounting sequence

Removing and installing cover for gearbox housing, clutch hous‐
ing, gearshift shaft with cover, drive shaft, output shaft, differential
and gearshift mechanism
Note
On gearboxes as of manufacturing date 06.09, the springs of the
sliding sleeve with synchronizer body for 3rd, 4th and 5th gear are
changed (the springs are longer), at the same time the synchron‐
izer ring for 3rd and 4th gear is changed as of this date ⇒
Electronic Catalogue of Original Parts .
Special tools and workshop equipment required
♦ Assembly stand -MP9-101-
♦ Pressure plate -MP3-406 (VW 401)-
♦ Pressure plate -MP3-407 (VW 402)-
♦ Thrust piece -MP3-408 (VW 412)-
♦ Guide bolt -T10079-
♦ Gearbox mount -T30012 (3221) -
♦ Insert base -T10083-
♦ Pressure plate -T10085-
♦ Sealant -AMV 188 200 03-
92
⇒ page 105
⇒ page 108
⇒ page 108
⇒ page 117