Skoda FABIA II 2007 Workshop Manual page 625

– Disconnect the Bowden cable support from gearbox
-arrows-.
– Tie up shift cable and selector cable.
– Place a non-fluffing cloth under the slave cylinder.
Note
Make sure no brake fluid comes into contact with the gearbox. If
this is the case, this point must be cleaned thoroughly.
– Pinch off the tube-hose line to the master cylinder with the
hose clamp - MP7-602 (3094)- (if the tube-hose line to the
master cylinder is made out of plastic, do not use the hose
clamp - MP7-602- ).
– Pull retaining clip -A- for tube-hose line out of the slave cylinder
up to the stop.
– Pull tube-hose line out of the support -C-.
– Pull tube-hose line -B- out of the slave cylinder and close
opening in a suitable manner.
– Unscrew slave cylinder -arrows- and take out.
Note
Do not depress the clutch pedal.
1.21.2 Install
Installation is performed in the reverse order, pay attention to the
following points:
– Grease tappet head with grease - G 000 100- .
– Install slave cylinder and tighten screws -arrows- to the given
tightening torque.
– Insert tube-hose line -B- into the slave cylinder up to the stop.
– Press in retaining clip -A- for attaching the tube-hose line up
to the stop.
– Press tube-hose line up to the stop into the support -C- at the
gearbox.
– After installing the slave cylinder bleed the clutch control
⇒ page 65 .
– Installing Bowden cable support, relay lever and gearshift lev‐
er:
♦ For vehicles Fabia II, Roomster and Rapid NH
♦ For vehicles Rapid ⇒ page 94
– Setting the shift mechanism
– Install the battery tray and battery ⇒ Electrical System; Rep.
gr. 27 .
– Install air filter ⇒ Engine; Rep. gr. 23 or ⇒ Engine; Rep. gr.
24 .
– Connect earth strap of battery ⇒ Electrical System; Rep. gr.
27 .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
.
⇒ page 96 .
Gearbox 02T - Edition 05.2014
⇒ page 89 .
63