Removing And Installing The Clutch Pedal With The Tension Spring; Removing And Installing The Clutch Pedal With The Tension Spring (Fabia Ii 2011 ►; Roomster 2011 ►) - Skoda FABIA II 2007 Workshop Manual

– Position the over-centre helper spring on the centering pin of
the clutch pedal -arrow-.
– The support -2- must be located on the actuating rod -1- of the
master cylinder.
– Press the support -2- into the recess on the clutch pedal -3-
until it clicks audibly into place.
– Press on clutch pedal slightly and insert a new bearing bolt.
– Position the pegs -A- horizontally.
– Turn the bearing bolt to the right -in direction of arrow-.
-1- = 8 mm Allan key.
• The catches -B- must click audibly into place.
Then the pegs -A- are positioned vertically.
– Press the support -2- into the recess on the clutch pedal -3-
until it clicks audibly into place.
– Install bracket without master cylinder
⇒ "1.10 Removing and installing the bracket without the mas‐
ter cylinder (Rapid) ", page 34
1.13 Removing and installing the clutch pedal
with the tension spring (Fabia II 2011 ►;
Roomster 2011 ►)
Note
Install the clutch pedal with a new bearing axle.
♦
If only the tension spring is removed, pay attention
♦
⇒ page 41 .
Special tools and workshop equipment required
♦ Hook - 3438-
♦ Pliers - T10005-
♦ Allan key, wrench size 8 mm, commercially available
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02R - Edition 08.2014
39