Removing And Installing The Gearbox Output R.p.m. Sender G195 - Skoda FABIA II 2007 Workshop Manual

– Remove the slide valve body
– Release screw -1-.
– Pull gearbox input r.p.m. sender -G182- with cable -A- out of
the gearbox.
Installing gearbox input r.p.m. sender -G182-
Installation is performed in the reverse order, pay attention to the
following points:
– Carefully press gearbox input r.p.m. sender -G182- up to the
stop into the gearbox.
Tightening torque
Component
Gearbox input r.p.m. sender -G182- to
gearbox, M6 screw
1.8 Removing and installing the gearbox
output r.p.m. sender - G195-
Note
General repair information
♦
Observe measures when disconnecting the battery ⇒ Elec‐
♦
trical System ⇒ Rep. Gr. 27 .
Removing gearbox output r.p.m. sender -G195-
WARNING
Observe measures when disconnecting and connecting the
battery ⇒ Electrical System ⇒ Rep. Gr. 27 .
– Disconnect the battery-earth strap with the ignition off ⇒ Elec‐
trical System ⇒ Rep. Gr. 27 .
– Removing the oil pan
– Removing oil filter ⇒ page 58
– Remove the slide valve body
⇒ page 58 .
⇒ page 3 .
⇒ page 56 .
.
⇒ page 58 .
1. Removing and installing oil pan, oil filter, slide valve body and internal wiring looms
Automatic 6-speed gearbox 09G - Edition 05.07
Nm
⇒ page 54
FABIA II 2007 ➤
73