Setting The Shift Mechanism - Skoda FABIA II 2007 Workshop Manual

– Apply a small quantity of grease -G 000 450 02- onto the studs
-arrows- of the gearbox shift lever -1- and of the relay lever
-2-.
– Always replace lock washers -3- and -4- after each removal ⇒
Electronic Catalogue of Original Parts .
– Secure the shift cable with the lock washer -3- and the selector
cable (for metal relay lever) with the lock washer -4-.
Cable lock with plastic relay lever
– Relay lever and cable lock must be installed together
⇒ page 56 .
– Insert the selector cable into the cable lock.
Continued for all gearshift mechanisms
– Align shift housing parallel to vehicle body.
• The distance to the vehicle body must be the same on both
sides.
– Assemble exhaust system free of stress and attach tunnel
bridges ⇒ Engine ⇒ Rep. Gr. 26 .
– If present, position the noise insulation on the shift housing.
– Install centre console ⇒ Body Work ⇒ Rep. Gr. 68 .

– Setting the shift mechanism

– Install air filter ⇒ Engine ⇒ Rep. Gr. 23 .
– Install battery and battery tray ⇒ Electrical System ⇒ Rep.
Gr. 27 .
Note
After the battery earth strap is disconnected and connected, carry
out additional operations ⇒ Electrical System ⇒ Rep. Gr. 27 .
Tightening torque
Components
Underbody cover
Shift housing to body
Cable support to gearbox
Tunnel bridge
Bracket for pre-exhaust pipe
1.9 Setting the shift mechanism
Special tools and workshop equipment required
♦ Rig pin -T10027A-
⇒ page 61 .
FABIA II 2007 ➤
Gearbox 02R - Edition 12.06
Tightening torque
2 Nm
⇒ page 51
⇒ page 53
⇒ Engine ⇒ Rep. Gr. 26
⇒ Engine ⇒ Rep. Gr. 26
61
1. Shift mechanism