Bleed The Clutch Control - Skoda FABIA II 2007 Workshop Manual

– Screw the slave cylinder at the gearbox with the screws -5-.
– Insert the tube-hose line -3- into the slave cylinder up to the
stop.
– Press in retaining clip -2- up to the stop.
– Press the tube-hose line into the bracket -4-, if present, at the
gearbox.
– After installing the slave cylinder bleed the clutch control
⇒ page 35 .
– Installing Bowden cable support, relay lever and gearshift lev‐
er ⇒ page 57 .
– Setting the shift mechanism
– Install air filter ⇒ Engine ⇒ Rep. Gr. 23 .
– Install battery tray and battery ⇒ Electrical System ⇒ Rep.
Gr. 27 .
– Connect earth strap of battery ⇒ Electrical System ⇒ Rep.
Gr. 27 .
Tightening torque
Component
Slave cylinder to gearbox
bracket for tube-hose line
Cable support to gearbox
Gearbox shift lever to gearbox
1.15

Bleed the clutch control

Special tools and workshop equipment required
♦ Brake filling and bleeding device e.g. -VAS 5234- or -ROM‐
ESS-
Note
♦ When performing the following work, make sure no brake fluid
comes into contact with the gearbox.
A pre-filling of the system is not necessary!
♦
After the battery earth strap is disconnected and reconnected,
♦
carry out additional operations ⇒ Electrical System ⇒ Rep.
Gr. 27 .
Brake fluid specification ⇒ Chassis ⇒ Rep. Gr. 00 .
– Remove battery and battery tray ⇒ Electrical System ⇒ Rep.
Gr. 27 .
– Remove air filter ⇒ Engine ⇒ Rep. Gr. 23 .
– Connect the brake filling and bleeding device .
To bleed use bleeder hose .
– Connect the ventilation hose with the drip bottle of the brake
bleeding device.
⇒ page 61 .
FABIA II 2007 ➤
Gearbox 02R - Edition 12.06
Tightening torque
⇒ Item 12 (page 28)
⇒ Item 12 (page 28)
⇒ page 53
⇒ page 53
1. Clutch control
35