Skoda FABIA II 2007 Workshop Manual page 416

Vehicles with start-stop system:
– Unclip clutch position sender -G476- at master cylinder
-arrow A- and -arrow B-.
– Remove the clutch position sender with connected electrical
plug connection from the master cylinder.
Continued for all vehicles
Note
When working in the footwell, protect the floor covering with cloths
from escaping brake fluid.
– Remove the footwell vent ⇒ Heating, Air Conditioning ⇒ Rep.
Gr. 87 .
– If present, release screws -arrows- and remove crash strut
-A-.
– Put steering wheel in the highest position.
– Remove clutch pedal switch -F36- -1-
– Unscrew the top fixing nut -arrow- for the bracket. To do so,
position an long extension on the nut in the opening between
the dash panel -2- and the bottom steering column trim panel
-3-.
– Unscrew the two lower fixing nuts -arrows-.
– Remove the bracket -A- from the front wall -B-.
1.6.2 Install
Installation is performed in the reverse order, pay attention to the
following points:
⇒ page 17 .
FABIA II 2007 ➤
Gearbox 02R - Edition 12.06
1. Clutch control
19