Roomster 2006 ►) - Skoda FABIA II 2007 Workshop Manual

– Detach return hose -A- at master cylinder and close with a
suitable tool e.g. closing tool - T10249/1- .
Note
Do not use the hose clamp - MP7–602- , otherwise the return
♦
hose -A- will be damaged.
When performing the following work, make sure that no brake
♦
fluid comes into contact with the frame side rail or the gearbox.
If this is the case, these points must be cleaned thoroughly.
– Remove the locking clip -B- on the master cylinder up to the
stop.
– Release and cut the tube-hose line -C- out of the master cyl‐
inder.
– Remove the storage area on the driver's side ⇒ Body Work;
Rep. gr. 70 .
– Remove crash strut (if present)
⇒ "1.2 Removing and installing the crash strut for the clutch
pedal (Fabia II 2007 ►; Roomster 2006 ►)", page 14
– Remove clutch pedal switch - F36-
⇒ "1.1 Summary of components - foot controls (Fabia II 2007
►; Roomster 2006 ►)", page 10
Note
To remove the master cylinder completely remove the clutch con‐
trol. Before removing first separate the master cylinder from the
clutch pedal.
Unlock the actuating rod/master cylinder from the clutch pedal as
follows:
– Pull clutch pedal slightly into the passenger compartment.
– Insert pliers - T10005- in the clutch pedal recesses.
– Press together both sides of the support inwards using the pli‐
ers - T10005- -arrows- and separate the clutch pedal from the
master cylinder.
– Removing the over-centre helper spring
⇒ "1.3 Removing and installing the over-centre helper spring
(Fabia II 2007 ►; Roomster 2006 ►)", page 14
– Remove the bearing/over-centre helper spring from the brack‐
et.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
-Pos. 7-, if provided.
Gearbox 02R - Edition 08.2014
.
.
49