Removing And Installing The Bracket Without The Master Cylinder; Fabia Ii 2011 - Skoda FABIA II 2007 Workshop Manual

1.7 Removing and installing the bracket
without the master cylinder; Fabia II
2011 ?
Special tools and workshop equipment required
♦ Pliers -T10005-
Removing
– Remove the footwell vent ⇒ Heating, Air Conditioning ⇒ Rep.
Gr. 87 .
– If present, release screws -arrows- and remove crash strut
-A-.
– Put steering wheel in the highest position.
– Remove clutch pedal switch -F36- -1-
– Unscrew the top fixing nut -arrow- for the bracket. To do so,
position an long extension on the nut in the opening between
the dash panel -2- and the bottom steering column trim panel
-3-.
– Unlock the actuating rod/master cylinder from the clutch pedal
as follows:
– Pull clutch pedal slightly into the passenger compartment.
– Press both sides of the support inwards using the pliers -
T10005- -arrows-
⇒ page 17 .
FABIA II 2007 ➤
Gearbox 02R - Edition 12.06
1. Clutch control
21