Remove And Install Gearshift Knob And Shift Lever Collar (Rapid Nh); Summary Of Components - Shift Lever And Shift Housing - Skoda FABIA II 2007 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02R - Edition 08.2014
1.6 Remove and install gearshift knob and
shift lever collar (Rapid NH)
Special tools and workshop equipment required
♦ Release tool - T30098-
♦ Hose strap pliers , e.g. -V.A.G 1275 A-
– Lever the collar frame out of the centre console. To do so, fit
the release tool - T30098- between the collar frame and the
cover of the centre console in the middle of the front side
-arrow 1- and press it forwards in -direction of arrow 2-.
– Lift off the frame.
– Pull the collar upwards over the gearshift knob.
– Open clamp -arrow- and pull off gearshift knob together with
the collar.
Install
– Turn collar inside out.
Note
When inserting the gearshift knob on the selector lever the gear‐
shift knob must lock up to the stop.
– Position the gearshift knob together with the collar and secure
it with the new open warm-type clamp -arrow- by pressing it
together.
– Fit the frame of the collar onto the catch pegs in the rear part
of the centre console.
– Press the frame into the cover of the centre console until it
locks in the front area.
1.7

Summary of components - Shift lever and shift housing

Note
Grease bearing and friction surfaces with grease - G 000 450 02- .
72
Rep. gr.34 - Controls, housing