Removing And Installing Gearshift Mechanism With Selector Lever Control Cable - Skoda FABIA II 2007 Workshop Manual

FABIA II 2011 ➤
Automatic gearbox 0AM - Edition 02.10
– Pull the cover -B- upwards over the handle.
– Disconnect plug -A- for lamp for selector lever scale illumina‐
tion -L101- .
– Open the warm-type clamp -arrow- below the handle and pull
off handle with cover.
2.5.2 Install
Installation is performed in the reverse order, pay attention to the
following points:
Note
The lock button must be fully pulled out for installing the se‐
♦
lector lever grip. Then the lock button must be secured using
a cable strap or with the assembly aid which was factory-de‐
livered together with the new grip.
If the lock button is not secured, it can no longer be pulled out
♦
of the selector lever grip using mechanical auxiliary tools.
Press out the lock button if necessary by positioning a com‐
pressed air pistol on the underside of the grip.
– Press the selector lever grip completely onto the selector lever
with a new warm-type clamp - the lock button points to the
driver.
• During this procedure, the grip must latch in the annular
groove on the selector lever.
– Remove cable strap or assembly aid. After the removal, the
lock button actuator engages into the vertical groove on the
selector lever. If necessary, press the lock button into the se‐
lector lever grip.
– Tighten new warm-type clamp using the hose binding claw .
2.6 Removing and installing gearshift mech‐
anism with selector lever control cable
Special tools and workshop equipment required
♦ Removal tool for the inner lining of the door panel -MP8-602/1-
2.6.1 Removing
– Removing the handle and cover for the shift mechanism
⇒ page 39 .
– Shift selector lever into position "S".
– Switch off ignition.
– Remove centre console ⇒ Body Work ⇒ Rep. Gr. 68 .
– Remove the noise insulation from the gearshift mechanism.
40
Rep. Gr.34 - Control, housing