Removing And Installing The Over-Centre Helper Spring (Fabia Ii 2007 ►; Roomster 2006 ►) - Skoda FABIA II 2007 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
1.5 Removing and installing the over-centre
helper spring (Fabia II 2007 ►; Roomster
2006 ►)
Special tools and workshop equipment required
♦ Pliers - T10005-
♦ Polycarbamide grease - G 052 142 A2-
Removing
– Remove the storage area on the driver's side ⇒ Body Work;
Rep. gr. 70 .
– Remove crash strut (if present)
– Remove clutch pedal switch
– Unlock the actuating rod/master cylinder from the clutch pedal.
Unlock the actuating rod/master cylinder from the clutch pedal as
follows:
– Insert pliers - T10005- in the clutch pedal recesses.
– Press together support and separate the clutch pedal from the
master cylinder.
– Push the over-centre helper spring against the bulkhead
-in the direction of the arrow- and remove from the bracket
from the bottom.
Install
– Insert bearing for over-centre helper spring -arrow 1- in the
bracket holder.
The peg of the bearing is located in the recess of the master cyl‐
inder -arrow 2-.
– Insert over-centre helper spring in the bearing.
24
⇒ page 22 .
⇒ page 19 -Pos. 7-, if provided.