Removing And Installing The Clutch Pedal With The Over-Centre Helper Spring (Fabia Ii 2011 ►; Roomster 2011 ►) - Skoda FABIA II 2007 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
1.13 Removing and installing the clutch pedal
with the over-centre helper spring (Fa‐
bia II 2011 ►; Roomster 2011 ►)
Note
Install clutch pedal with new bearing bolt.
♦
If only the over-centre helper spring should be removed, the
♦
clutch pedal must not be separated from the master cylinder.
Special tools and workshop equipment required
♦ Pliers - T10005-
♦ Allan key, wrench size 8 mm, commercially available
Removing
– Removing the footwell vent ⇒ Heating and Air Conditioning;
Rep. gr. 87 .
– If present, remove crash strut
– Remove clutch pedal switch - F36-
– Unlock the actuating rod/master cylinder from the clutch pedal
as follows:
– Pull clutch pedal slightly into the passenger compartment.
– Press together both sides of the support using the pliers -
T10005- -arrows-.
– Remove the bearing bolt for the clutch pedal.
– Turn the bearing bolt for the clutch pedal to the left
-in direction of arrow-, for this purpose use the hexagon socket
wrench -1-, wrench size 8 mm.
While doing so, the catches -A- are destroyed.
Then the bolts -B- are positioned horizontally.
– Subsequently move the clutch pedal so that the bearing bolt
can be pulled out.
– Remove over-centre helper spring.
– Remove clutch pedal from bracket.
Install
• Install the clutch pedal with a new bearing bolt.
46
⇒ page 32 .
⇒ page 31 .