Skoda FABIA II 2007 Workshop Manual page 684

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
– Pressing the sleeve of the 5th gear sliding gear needle bearing
onto the drive shaft
– Place the drive shaft -2- and output shaft -1- with bearing sup‐
port for grooved ball bearing in the pressure plate -T10085- .
– Insert the gearshift mechanism (shift forks) -4- in the sliding
sleeves of the shaft.
– Insert the shaft for reverse gear -3- with the reverse gear.
– Screw the guide bolt -T10079- onto the reverse shaft support
-arrow-.
– Insert the components together into the gearbox housing, by
passing the guide bolt -T10079- through the fixing holes of the
gearshift mechanism in the gearbox housing.
– Unscrew -T10079- guide bolt.
– Check before pressing on the bearing support:
♦ To click in the shift forks into the sliding sleeves correctly.
♦ Dimension -a- of the output shaft serration.
Note
♦ The drive shafts of the individual gearboxes have different
lengths due to the different heights of the serration, dimension
-a-.
In order to press in the drive shaft and the output shaft at the
♦
same time, a 3 mm thick washer - T10083/1- must be posi‐
tioned onto the drive shaft, if necessary.
Therefore, the dimension -a- of the output shaft serration must
♦
be measured.
• Dimension -a- = 30.6 mm
122
⇒ page 135 .