Removing And Installing The Over-Centre Helper Spring; Fabia Ii - Skoda FABIA II 2007 Workshop Manual

1.5 Removing and installing the over-centre
helper spring; Fabia II 2007 ?
Special tools and workshop equipment required
♦ Pliers -T10005-
♦ Polycarbamide grease -G 052 142 A2-
Removing
– Remove the storage area on the driver's side ⇒ Body Work
⇒ Rep. Gr. 70 .
– Remove crash strut (if present)
– Remove clutch pedal switch
– Unlock the actuating rod/master cylinder from the clutch pedal.
Unlock the actuating rod/master cylinder from the clutch pedal as
follows:
– Insert pliers -T10005- in the clutch pedal recesses.
– Press together support and separate the clutch pedal from the
master cylinder.
– Push the over-centre helper spring against the partition panel
-in the direction of the arrow- and remove from the bracket
from the bottom.
Install
– Insert bearing for over-centre helper spring -arrow 1- in the
bracket holder.
The peg of the bearing is located in the recess of the master cyl‐
inder -arrow 2-.
– Insert over-centre helper spring in the bearing.
⇒ page 13 .
⇒ Item 7 (page 10) , if provided.
FABIA II 2007 ➤
Gearbox 02T - Edition 12.06
15