Removing And Installing The Clutch Pedal With The Over-Centre Helper Spring; Fabia - Skoda FABIA II 2007 Workshop Manual

1.8 Removing and installing the clutch pedal
with the over-centre helper spring; Fabia
II 2011 ?
Note
Install the clutch pedal with a new bearing axle.
♦
If only the over-centre helper spring should be removed, the
♦
clutch pedal must not be separated from the master cylinder.
Special tools and workshop equipment required
♦ Pliers -T10005-
♦ Allan key, wrench size 8 mm, commercially available
Removing
– Remove the footwell vent ⇒ Heating, Air Conditioning ⇒ Rep.
Gr. 87 .
– If present, release screws -arrows- and remove crash strut
-A-.
– Remove clutch pedal switch -F36-
– Unlock the actuating rod/master cylinder from the clutch pedal
as follows:
– Pull clutch pedal slightly into the passenger compartment.
– Press both sides of the support inwards using the pliers -
T10005- -arrows-
⇒ page 17 .
FABIA II 2007 ➤
Gearbox 02R - Edition 12.06
1. Clutch control
23