Check The Function Of The Ignition Key Removal Lock - Skoda FABIA II 2007 Workshop Manual

– Release screw -2- at the front ball socket of the selector lever
control cable -1-.
– Tip selector lever in position "P" slightly to the front and to the
rear, however under no circumstances move out of "P".
– Position the gearshift lever -3- at the gearbox in "P", i.e. push
the gearshift lever fully backwards against the direction of
travel.
Note
Locking lever must engage in parking gear, both front wheels are
blocked (cannot be simultaneously turned in one direction).
– Tighten screw -2-.
– Inspect gearshift mechanism
⇒ "2.2 Inspecting the gearshift mechanism", page 54
Tightening torque
Component
Adjusting screw for
selector lever control
cable
2.4 Check the function of the ignition key re‐
moval lock
– Switch on the ignition - do not start the engine.
– Depress brake pedal and hold pressed.
• Shifting the selector lever out of the position "P" when the lock
button is pressed at the grip of the selector lever must be pos‐
sible without "jerking".
– Switch off ignition.
• The key cannot be withdrawn from the ignition starter switch
in any other selector lever position except in the position "P".
– Shift selector lever into position "P".
– Withdraw ignition key.
• Only withdraw the key from the ignition starter switch if the
selector lever is in position "P".
• The selector lever cannot be shifted out of position "P" when
the button is pressed and the brake pedal is actuated.
If the ignition key removal lock does not function as described:
♦ Inspecting and adjusting the selector lever control cable
⇒ "2.3 Inspecting and adjusting the selector lever control ca‐
ble", page 55 .
♦ Inspect the vehicle ⇒ Vehicle diagnostic tester in the function
"Targeted fault finding".
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Nm
13
Gearbox 09G - Edition 07.2014
.
2. Repairing shift mechanism
57