Removing And Installing Gearbox Mount - Skoda Octavia III 2013 Workshop Manual

– Connect supporting device - T30099- as shown in the illustra‐
tion.
Note
On the Yeti, instead of base - T30119- use base - T30099/1- .
– Attach snap hook to the engine suspension eye, right.
– Slightly pre-tension engine/gearbox unit with the spindle, do
not raise.
– Release screws -1- to -6- and remove engine mounting.
Install
Installation is performed in a similar way in the reverse order. Pay
attention to the following points:
– Check assembly bracket setting
Tightening torques
♦ Assembly bracket
⇒ "2.2 Assembly bracket - Summary of components (Yeti)",
page 35
2.5

Removing and installing gearbox mount

Special tools and workshop equipment required
♦ Supporting device - T30099-
♦ Surface - T30119-
♦ Surface - T30099/1-
♦ Hook for MP9-200 and T30099 - MP9-200/10 (10-222A/10)-
♦ Adapter - MP9-200/18 (10-222A/18)-
♦ Support - 10-222A/31-3-
♦ Clutch - T40091/3-
Removing
– Remove air filter housing
– Remove battery and battery tray ⇒ Electrical System; Rep.
gr. 27 .
Octavia III vehicles
– Remove engine control unit
– Unscrew screws -arrows- and remove holder -1-.
Note
Holders are installed differently according to build version.
Continued for all vehicles
Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
⇒ page 41 .
⇒ page 235 .
⇒ page 252 .
1.6/81 kW MPI engine - Edition 06.2014
39
2. Assembly bracket