Removing And Installing The Bracket Without The Master Cylinder; Removing And Installing The Bracket Without The Master Cylinder (Rapid 2011 ►) - Skoda FABIA II 2007 Workshop Manual

Master cylinder to front wall
1)
Replace self-locking nut.
1.11 Removing and installing the bracket
without the master cylinder (Fabia II
2011 ►; Roomster 2011 ►; Rapid NH
2013 ►)
Special tools and workshop equipment required
♦ Pliers - T10005-
Removing
– Removing the footwell vent ⇒ Heating and Air Conditioning;
Rep. gr. 87 .
– If present, remove crash strut
– Put steering wheel in the highest position.
– Remove clutch pedal switch - F36- -1-
– Unscrew the top fixing nut -arrow- for the bracket. To do so,
position an long extension on the nut in the opening between
the dash panel -2- and the bottom steering column trim panel
-3-.
Unlock the actuating rod/master cylinder from the clutch pedal as
follows:
– Pull clutch pedal slightly into the passenger compartment.
– Press together both sides of the support using the pliers -
T10005- -arrows-.
– Unscrew the two lower fixing nuts -arrows-.
– Remove the bracket -A- from the front wall -B-.
• The master cylinder is locked into position with the bracket.
• When removing the bracket, the master cylinder in the engine
compartment must be held by a 2nd mechanic.
Install
Installation is performed in the reverse order, pay attention to the
following points:
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
1)
⇒ page 32 .
⇒ page 31
Gearbox 02T - Edition 05.2014
⇒ page 36
.
-Position 4-
43