Bleeding The Clutch Control - Skoda FABIA II 2007 Workshop Manual

1.22

Bleeding the clutch control

Special tools and workshop equipment required
♦ Brake filling and bleeding device , e. g. -VAS 5234-
Note
If the battery earth strap is disconnected and connected, carry
♦
out additional operations ⇒ Electrical System; Rep. gr. 27 .
During the following work, ensure that no brake fluid lands on
♦
longitudinal member or gearbox.
A pre-filling of the system is not necessary!
♦
Brake fluid specification ⇒ Chassis; Rep. gr. 00 .
– If present, remove engine cover ⇒ Engine; Rep. gr. 10 .
– Disconnect the battery-earth strap with the ignition off ⇒ Elec‐
trical System; Rep. gr. 27 .
– Remove air filter ⇒ Engine; Rep. gr. 23 or ⇒ Engine; Rep.
gr. 24 .
– Remove battery and battery tray ⇒ Electrical System; Rep.
gr. 27 .
– Connect the brake filling and bleeding device.
– Fit the bleeder hose -A- on the vent valve of the slave cylinder
-arrow- and open the valve.
– Activate system with a brake fluid pressure of 0.2 MPa.
– Allow approx. 100 cm
air bubbles are visible.
– Close vent valve.
– Rapidly operate pedal from stop to stop 10 to 15 times.
– Open vent valve.
– Activate system with a brake fluid pressure of 0.2 MPa.
– Allow another approx. 50 cm
– Close vent valve.
– After completing the bleeding procedure activate the clutch
pedal repeatedly.
– If necessary, bleed the clutch control once again
– Disconnect bleeding device.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
3
of brake fluid to flow out until no more
3
of brake fluid to flow out.
Gearbox 02T - Edition 05.2014
⇒ page 65 .
65