FABIA II 2011 ➤
Automatic gearbox 0AM - Edition 02.10
– Tighten all the screws for the mechatronics for double clutch
gearbox -J743- crosswise to the tightening torque
⇒ page 47
.
– Carefully turn the assembly lever -T10407- to the right and
remove.
– Insert the gearbox input r.p.m. sender 3 -G641 - in
-direction of arrow- in the gearbox housing.
Note
Look at the sender . The clip must not be damaged.
♦
The sender must be positioned completely and tightly with its
♦
tab on the gearbox housing. If the sender is "loose", the clip is
broken, replace the mechatronics.
– Remove the screw plug from the ventilation and position the
ventilation cap.
3.7
Install mechatronics for double clutch
gearbox -J743 - ; gearbox installed
Special tools and workshop equipment required
♦ Assembly lever -T10407 -
♦ Guide bolt -T10406-
♦ Catch pan for workshop crane -VAS 6208-
66
Rep. Gr.34 - Control, housing