Removing And Installing, Setting Angular Clutch Pedal Switch F36; Removing And Installing, Setting Cylindrical Clutch Pedal Switch F36 - Skoda FABIA II 2007 Workshop Manual

FABIA II 2007 ➤
Gearbox 02T - Edition 12.06
1.2 removing and installing, setting angular
clutch pedal switch -F36-
Note
The clutch pedal switch -F36- may only be installed once to en‐
sure that it has an adequately tight fit in the bracket.
Removing
– Remove the storage area on the driver's side ⇒ Body Work
⇒ Rep. Gr. 70 .
– Unplug connector from the clutch pedal switch -F36- .
– Turn clutch pedal switch -F36- 90° to the left and remove it
from the support.
Installing and setting
– Remove tappet up to the stop
– Press down the clutch pedal by hand as far as possible.
– Insert clutch pedal switch into the support and turn switch 90°
to the right.
– Insert connector for the clutch pedal switch -F36- .
– Install the storage area on the driver's side ⇒ Body Work ⇒
Rep. Gr. 70 .
1.3 removing and installing, setting cylindri‐
cal clutch pedal switch -F36-
Note
The clutch pedal switch -F36- may only be installed once to en‐
sure that it has an adequately tight fit in the bracket.
– Remove the storage area on the driver's side ⇒ Body Work
⇒ Rep. Gr. 70 .
– Unplug connector -1- from the clutch pedal switch -F36- .
– Turn clutch pedal switch -F36- -2- in the bracket 45° to the left
and remove it from the support.
Note
The clutch pedal remains in the off position in this case (do not
depress).
Installing and setting
12
Rep. Gr.30 - Clutch