Skoda FABIA II 2007 Workshop Manual page 119

FABIA II 2011 ➤
Automatic gearbox 0AM - Edition 02.10
– Turn the clutch against the extractor by hand so that the clutch
is thus located in its fitting position.
• Only turn the clutch by hand, do not use any tool.
Only turn by hand. In this way, the clutch slips against the circlip.
Do not use any further tool.
By pressing on the "clutch it is positioned at the bottom" on the
drive shaft. The clutch should only be pulled up as far as neces‐
sary until it touches the circlip.
Subsequently insert the hub:
The hub has a "large" tooth and therefore only fits in one position.
On the -engine side-, the "large" tooth has a marking -arrow-.
– Install the hub with the marking on the "large tooth" in such a
way that it is flush with the marking on the drive plate
-arrow-.
28
Rep. Gr.30 - Clutch