Repairing Shift Mechanism; Inspecting The Gearshift Mechanism - Skoda FABIA II 2007 Workshop Manual

FABIA II 2007 ➤
Automatic 6-speed gearbox 09G - Edition 05.07
2

Repairing shift mechanism

2.1

Inspecting the gearshift mechanism

WARNING
Before working on the engine when the engine is running, in‐
sert the selector lever in position "P" and apply handbrake.
♦ In selector lever positions "S", "D", "R" and Tiptronic position
it must not be possible to activate the starter.
♦ At speeds above 5 km/h and shifting in selector lever position
"N" the selector lever lock solenoid must not engage and block
the selector lever. Selector lever can be shifted in a driving
position.
♦ At speeds below 5 km/h (virtual standstill) and shifting in se‐
lector lever position "N" the selector lever lock solenoid must
only engage after approx. 1 s. The selector lever can only be
moved from position "N" by activating the brake pedal.
Selector lever in position "P" and ignition switched on:
• Brake pedal is not operated:
The selector lever is locked and cannot be moved out of position
"P". The selector lever lock solenoid blocks the selector lever.
• Brake pedal is operated:
The selector lever lock solenoid releases the selector lever. It is
possible to engage a driving gear position. Slowly shift selector
lever from "P" through "R, N, D, S"; while doing so check whether
the selector lever position in the dash panel insert corresponds
with the actual selector lever position.
Selector lever in position "N" and ignition switched on:
• Brake pedal is not operated:
The selector lever is locked and cannot be moved out of position
"N". The selector lever lock solenoid blocks the selector lever.
• Brake pedal is operated:
The selector lever lock solenoid releases the selector lever. It is
possible to engage a driving gear position.
Selector lever in position "D" ignition and light switched on:
• Selector lever in Tiptronic gear leads to:
The lighting up of the "D" symbol in the selector lever position
indicator should go out and the "+" and "-" symbols should light
up.
When the gear selector lever is put into the Tiptronic gate, the
selector lever position display in the dash panel insert should
change from "PRNDS" to "654321".
– Move selector lever in the Tiptronic gear to "+" and "-".
When the gear selector lever is put into a higher or a lower driving
position, the selector lever position display in the dash panel in‐
sert should change.
– Inspecting and adjusting the selector lever control cable
⇒ page 23 .
22
Rep. Gr.37 - Control, housing