Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02R - Edition 08.2014
2
Removing and installing the gearbox
⇒ "2.1 Removing gearbox (Fabia II 2007 ►; Roomster 2006 ►)",
page 90
⇒ "2.2 Removing gearbox (Fabia II 2011 ►; Roomster 2011 ►)",
page 97
⇒ "2.3 Removing gearbox (Rapid) ", page 106
⇒ "2.4 Removing gearbox (Rapid NH)", page 113
⇒ "2.5 Installing the gearbox", page 120
⇒ "2.5.1 Tightening torques (Fabia II, Roomster) ", page 122
⇒ "2.5.2 Tightening torques (Rapid) ", page 124
⇒ "2.6 Tightening torques (Rapid NH)", page 125
⇒ "2.7 Transporting the gearbox", page 126
2.1
Removing gearbox (Fabia II 2007 ►;
Roomster 2006 ►)
Special tools and workshop equipment required
♦ Supporting device - MP9-200 (10-222A)-
♦ Adapter - MP9-200/3 (10-222A/3)-
♦ Gearbox mount - 3282-
♦ Adjusting plate - T30020-
♦ Engine and gearbox jack e.g. -V.A.G 1383 A-
♦ Grease for plug serration of clutch disc - G 000 100-
Note
All cable straps which are detached or cut open when remov‐
♦
ing, should be fitted on again in the same place when installing.
♦
After the battery earth strap is disconnected and re-connected,
carry out additional operations ⇒ Electrical System; Rep. gr.
27 .
– Disconnect the earth strap from the battery with the ignition
off.
– Remove engine cover ⇒ engine; Rep. gr. 10 .
– Remove air filter housing complete with air guide hose ⇒ En‐
gine; Rep. gr. 23 .
– Remove battery and battery tray ⇒ Electrical System; Rep.
gr. 27 .
90